|
Installation:::...
There's
nothing much to report on the installation front.
Provided you have the requisite two (or possibly one)
4-pin Molex power connector available you should be
good to go with a minimum of fuss.
Test
System Setup:::...
Epox
8RDA3G (nForce2 Ultra400) (Kindly supplied by Epox)
2x256MB
Corsair (TWINX3200LL) Memory (Kindly Supplied By Corsair)
AMD
AthlonXP 3200+ (Kindly Supplied By AMD)
WD80JB
80GB Hard Drive (Kindly Supplied By Western
Digital)
Windows
XP Pro + SP1
NVIDIA
ForceWare 61.11 drivers
Throughout
testing the following driver settings were used:
Antialiasing,
Anisotropic Filtering and V-sync are all set to "OFF"
unless stated otherwise.
Trilinear
Optimisations are left at the default "ON"
position unless stated otherwise. (This setting can
only be changed using NV4x GPUs). In light of the
recent ATi revelations this seemed fairest.
The
image quality slider is set to the "Quality"
position unless stated otherwise.
Before
the going any further, I decided to try out the performance
running on just a single power feed......
|
