Page 4 of 4

Some people have complained about the mouse being wobbly, but that depends entirely on what kind of surface you’re on. I didn't find this mouse to be wobbly at all while using it myself.

Normally, wireless mice have either batteries that you need to replace or static chargeable batteries, both of which leave you guessing as to the state of charge.

This mouse however shows the charge that is left in the battery at any given time, which is really useful.

When the battery is fully charged, all lights turn green. Each light goes out, one after another, as the battery capacity begins to fall.

This mouse was halfway charged when I got, I charged it for about 30 minutes to full charge.

Right now writing this article and having used the mouse for half a week, the battery still still shows a full charge which I find impressive.

The mouse has a built-in power save feature, when it’s not used it turns itself off. That prolongs the charge in the battery.

The mouse also has a number of buttons available. Each of which have their own default function, of course you can adjust this using SetPoint.

I left it at default, because I found them very useful.

These buttons on the left side of the mouse have several functions. The arrows are for moving back and forth in the page history of a browser.

The icon of 2 little screens is for switching between programs.

These buttons are located on the front of the mouse.

Everyone usually knows the scroll button, it’s for scrolling in documents or websites, pretty much anything with a scrollbar.

The double arrows pointing up and down are the cruise control scroll buttons. This is for when you have a long document or website to scroll through. It allows you to scroll though fast.

The scroll button itself is clickable too and it enables the zoom, the up and down arrows allow you to zoom in or out then. You can scroll from side to side too, pushing the scroll button to the left or right as indicated by the arrows, a function that was recently introduced in Microsoft's mouse range..

There were some reports about people having the mouse do some irregular actions.

When you make circles and do donuts with the mouse cursor on the screen the cursor would suddenly jump to another section of the screen. This is due to the charging base station/receiver being to close to the monitor or case. The manual clearly states that the receiver should be placed a considered amount away from those devices, because they can cause interference.

It is time to put the mouse through its paces.

I have used this mouse in games like Unreal Tournament 2004 and Star Wars Battlefront. It works like a charm, in fact better then my optical mouse that still has the steel grip pads on them.

I had some concern about using the mouse to turn, but it was unfounded, turning happens smoothly with no delays.

Again here have been some issues reported about delays being observed when turning around in fast action games. I couldn’t find any, however I can imagine that some people use their mouse differently.

Some people pick up their mouse to move from side to side or turn around, this changes the scan surface which in turn might cause a delay.

In the course of writing this review I had to switch back to my regular mouse on a few occasions. This was a very unpleasant surprise for me as my regular mouse felt slow and awkward after the MX1000. The freedom of movement was limited and I couldn’t wait to use the MX-1000 again.

The only thing I have not been able to test is the time it takes to charge the mouse completely, simply because the mouse didn’t run out of power yet.

I think this is a good thing, because even if the charge time is long you could let it charge at night when you sleep, but I don’t think charging the mouse would take long.

There seems to be little wrong this mouse in fact I find nothing wrong with it at all.

Perhaps there is one thing left to mention, this mouse only comes in right handed design.

I think this will change in the near future and then maybe the lefties can enjoy this mouse as much as I have.

USB Hack

There’s a hack for the USB port to get a higher polling frequency over here. It explains how to hack the usbport.sys to increase the frequency.

There also some software to test it.

I’ve tried the hack at 250 MHz and 500 MHz and neither works for this mouse, the test software still shows 125 MHz which is the default frequency. So I didn’t achieve any gains there.

Of course I did check whether or not the hack works and it does.

This screenshot was taken with a normal optical mouse by Logitech.

This means that the MX-1000 is protected from these hacks.

Conclusion

The 3DVelocity 'Dual Conclusions Concept' Explained: After discussing this concept with users as well as companies and vendors we work with, 3DVelocity have decided that where necessary we shall aim to introduce our 'Dual Conclusions Concept' to sum up our thoughts and impressions on the hardware we review. As the needs of the more experienced users and enthusiasts have increased, it has become more difficult to factor in all the aspects that such a user would find important, while also being fair to products that may lack these high end "bonus" capabilities but which still represent a very good buy for the more traditional and more prevalent mainstream user. The two categories we've used are:

The Mainstream User ~ The mainstream user is likely to put price, stock performance, value for money, reliability and/or warranty terms ahead of the need for hardware that operates beyond its design specifications. The mainstream user may be a PC novice or may be an experienced user, however their needs are clearly very different to those of the enthusiast, in that they want to buy products that operate efficiently and reliably within their advertised parameters.

The Enthusiast ~ The enthusiast cares about all the things that the mainstream user cares about but is more likely to accept a weakness in one or more of these things in exchange for some measure of performance or functionality beyond its design brief. For example, a high priced motherboard may be tolerated in exchange for unusually high levels of overclocking ability or alternatively an unusually large heat sink with a very poor fixing mechanism may be considered acceptable if it offers significantly superior cooling in return.

The Mainstream User ~

This mouse is easy to install and very easy to use and it boasts a lot of features.
Movement is smooth and because it is wireless you have more freedom of movement.
The price might be a little higher then the mainstream might want to spend, but it sure earns it back easily.
Day to day work as well as games work more efficient, using the new laser scanning technology.

The Enthusiast ~

Pretty much the same story here, the mouse hosts a lot of useful features.
It's a sturdy design and the mouse feels smooth and fast.
Gaming with this mouse is a pleasure with no discernable lag, game play is smooth and the freedom of movement with your mouse is great.
The enthusiast users will love this mouse.

We're always looking for ways to make our reviews fairer. A Right To Reply gives the manufacturer or supplier of the product being reviewed a chance to make public comments on what we've said. They can explain perhaps why they've done the things we were unhappy with or blow their own trumpet over the things we loved. It's easy for us to pick a product apart but sometimes things are done a certain way for very specific reasons.

Should Jetart decide to exercise their "Right To Reply", we'll publish their comments below: